Fiat Ducato 9 V1 Sound Kit DSP Amplifier + ROCK-1 Subwoofer Option

  
This product sheet was automatically translated. If you have any questions, please feel free to contact us. More bass and perfectly tuned sound for the Fiat Ducato Series 9 with factory radio preparation.

This V1 set is the right solution for your Fiat Ducato Series 9 if you have already installed the speakers and want to add more bass and more control to the vehicle in the next step. The compact DSP power amplifier and the Rock-1 passive subwoofer can be integrated neatly and quickly via Plug & Play using the supplied cable harness.

The digital design generates little heat, so the power amplifier can be installed invisibly in the radio slot. This audio system fits directly if you have installed an aftermarket radio with an ISO connection.

If you have a factory-installed FIAT radio, you will also need a suitable T-harness for the Fiat Ducato Series 9. If you have installed the 10-inch U-Connect radio, you will need the appropriate complete kit for this radio variant instead.

Note on the subwoofer: The passive under-seat subwoofer can be installed directly and flush under the seat of the Fiat Ducato Series 9, provided that no second battery is installed there.

What this set gives you. The ultra-compact DSP6 power amplifier can be quickly integrated thanks to the included cable harness and provides the front system and subwoofer with much more control and bass.

This allows you to make better use of the potential of your already prepared front system. DSP power amplifier for more control, more dynamics, and clean control of the front system. Rock-1 under-seat subwoofer for stronger and cleaner bass in the camper van. Plug & Play integration without complex modifications to the vehicle wiring. Invisible installation of the power amplifier in the radio slot thanks to its compact design and low heat generation.

Two channels are used for the front system, and two additional channels are available for the rear speakers and a passive subwoofer. Two additional channels are available via the line output connection to connect active subwoofers or additional power amplifiers and control them via the DSP.

In combination: The DSP power amplifier and the Rock-1 subwoofer provide more bass, greater level stability, and a noticeably more balanced sound in the Fiat Ducato Series 9. Installation is done via Plug & Play using the included cable harness.

The set fits directly with upgraded radios with an ISO connection. The DSP power amplifier can be installed invisibly in the radio slot. The Rock-1 subwoofer is mounted precisely under the seat, unless a second battery is installed there. For factory-installed FIAT radios or the 10-inch U-Connect radio, the correct variant or suitable adapter must be used. If you have any questions about installation, the product, or the correct radio variant, we will be happy to help.

If you have a factory-installed FIAT radio, a suitable T-harness is also required. The appropriate complete kit is required for the 10-inch U-Connect radio. 1 x OPTION DSP6 power amplifier incl. DSP configuration already installed for your vehicle.

1 x Rock-1 subwoofer (4.3 kg). 1 x cable harness for Plug & Play installation, incl.

Highly efficient 6-channel DSP amplifier.

6-channel amplifier / 8-channel DSP. 6 x 60 watts RMS (4 ohms). 4 x 60 watts RMS (4 ohms) + 1 x 120 watts RMS (switchable 2-ohm mono mode). Channels 5 and 6 are used in stereo mode for subwoofers. Minimum impedance on all stereo channels: 3 ohms. Minimum impedance in mono operation: 1.5 ohms.

ADEP diagnostic protection for easy connection to OEM radios. Start/stop compatible up to 5 seconds at 6 volts. High-level input (4 channels) with automatic turn-on/off. Frequency range: 20 Hz to 21 kHz.

Integrated 8-channel DSP processor, 358 kHz. Operating voltage: 10.3 V - 17.5 V. Power reduction in medium-power mode. Minimum dimensions for easy retrofitting. 94 x 149 mm x 32 mm (118 x 149 mm with bracket). Quiescent current in standby: 0.6 mA. Main connection: Molex MiniFit Jr. Subwoofer connection: Molex MiniFit Jr. Programming port for DSP Eprom: RJ-45 modular jack. Remote connection: RJ-45 modular jack.

All necessary information and payment options are displayed in this process. You will also find all relevant information regarding your purchase. If you encounter any problems, please call us! We will inform you as soon as we have received your payment and handed your goods over to DHL. Except during the lunch break from 12:00. As the seller, we always bear the shipping risk for private customers in accordance with the law. All necessary information and payment options are displayed.